Can pulling out a wire on a flashing light for a factory security alarm sytem cause the vehicle not to start? - light factory serial mac
Ok, so I launched the script to work on my radio, and it is connected to a cable to a flashing red light. I connected the cable from the light, which is connected to the piece on the board. This is a Ford Ranger 1992nd However, custom truck battery to start the competence not only to be delivered. I have a new start in about 6 months. I do not think that it is.
Tuesday, January 26, 2010
Light Factory Serial Mac Can Pulling Out A Wire On A Flashing Light For A Factory Security Alarm Sytem Cause The Vehicle Not To Start?
5 comments:
The security system generally cut the ignition systems and start to make sure that when the engine is running.
If you change the ignition to the lighting of the dashboard, oil, battery, brakes, lights, etc., or not? Please turn on change is good security system for such damage.
The flashing light is an LED (light emitting diode) and may form part of the circle, it is very likely that this is the problem.
In addition, make sure the other son are also likely to lose if it can happen that can happen to other cables.
By manipulating the alarm can kill a switch.You could not have caused you remove the battery cable for about 5 minutes, then reinstall. This will need to open in May code.But Ford restoration of security to system.Give on some Ford models to try.
If I could, the first identification of the owner's brand, but in general, all cables must be present security systems, it will be disabled if that fails, try the backup cable hooks and see if it helps to have, I have a disability in a probe of 93, after she did not start and had to block it again, good luck with it.
Kill switches usually do not disable the starter! With the truck in the park trying to avoid a switch to the starter solenoid and to see whether it is
The LED flashes red part of the system that the chip is embedded in their key detects. If the cable anti-theft system, "meaning," the anti-theft and disable the ignition to get around - to do something. By all means the rest of the controls, but suggested connecting the backup LED.
Post a Comment